Printing a coaster I got from the internet

Hello again fans,

Since I took today and tomorrow off work (small vacation) and given the fact that I am forced to stay at home because of COVID-19, here goes another blog post.

Tonight I am 3D printing a coaster for holding my beer when I am working remotely from home. Pic below (still couldn’t see anything, took the photo on the beginning of the process).

Also, it has been a while since I came down to my garage to continue the several projects going on. The featured image on the top of this post is of my to be plotting machine. I am currently testing the motors, that are controlled by an Arduino with a shield on it.

And not forgetting about the temperature sensing device, that is almost done, I just have to make a permanent circuit for it. Picture below :

Well, that’s it for now. When the coaster is done printing I will make another post with a picture of it.

See ya

Leave a Reply

Your email address will not be published. Required fields are marked *